USB
OKI’s ML60842 - USB 2.0 full-speed OTG Controller
Common Features
- Complies with USB Rev. 2.0 (Full and low speed)
- ARM type controller interface
- VBUS detection, VBUS charge/discharge circuit
- Pin selectable 16/32-bit, host/device, little/big endian
- Common connector specification (host controller)
- Master clock 48MHz
- Host Controller
MS Windows Open HCD driver standard
- Open HCI standard 1.0a
- Supports four data transmission modes
- DMA slave function, 1 channel, less software overhead
- Supports one USB port (12/1.5Mbps), connectable to transceiver
Device Controller
- Full speed, 12Mbps, bus-powered
- Four data transmit modes: Control, bulk, interrupt and isochronous modes
- Embedded 6 end-points (EP)
- Control end-point x 1
- Bulk interrupt end-point x 3
- Isochronous/bulk interrupt end-point x 1 or x 2
- Data transfer FIFO
- Twin FIFO for EP1, EP2, EP4, EP5
- DMA transfer possible for EP1, EP2, EP4, EP5 (2 channels)
- Built-in transceiver (Vdd +3.0 ~ 3.6V)
Please contact your nearest Elatec Office for further details
